Puffy 3D Foam
Sheet size: 40cm x 30cm and 3mm thick.
EVA Foam (PE20) available in 2 colours - white & black. Exact colour matches are not required, as the foam is covered with stitches to produce the 3D effect. Each pack contains 10 sheets of the single chosen colour.
By buying this product you can collect up to 7 loyalty points. Your cart will total 7 points that can be converted into a voucher of £0.07.
Place Puffy Foam on the fabric to be embroidered and attach it with adhesive spray KK, if needed.
Satin stitch your design. The machine needle penetrates the foam during stitching. A double stitch density (0.2) instead of the standard setting is essential for completely covering and encasing Puffy during stitching. Use satin stitches, not fill stitches as these will destroy the foam. The wider the satin stitch, the stronger 3D effect will be achieved.
A needle with SES point will perforate Puffy better than needles with sharp points.
An extremely strong 3D effect can be achieved by using two layers of Puffy on the base fabric. If needed, bond it with an adhesive spray.